Recent content by church

I would go with plasterer 1 , but key is ventilation in the bathroom area when you are talking about mould .

Hi , ive never used sand in a sbr slurry , are you talking about brickwork walls or blockwork ? what type of bricks / blocks

Hi who advised you ?

Thanks for all the replies lads

Allready fixed and stuck on meshed on im afraid

The builder wants to use k rend uf base , as there have some over from another job .

STO have sent the wrong beads , there customer service was not good ,it would double the cost to dub out with armat , i knew very little about there system tbh , they sent 10mm drips and 6mm stops . They then said the total thickness was only 4mm for both coats . So every thing was set up wrong...

HI all , i need to dub out ventec board prior to sto base coat and top coat , what products can be use please, i need about 6mm thickness , thanks .

All good here mate , hope you and the family are all good , and your earning a few quid ! I must admit im a bit concerned about the basecoat but the job is a hack off and re-do and what was on there before is not that good , so i cant go that far wrong lol .

Ok thanks for that , ive done a few thin coats , but first time with Sto .

so you finish base coat with the spat ?

A render panel i belive , its a spec from STO

sto armat classic plus is the product . Thanks

I will find out today and let you know thanks .

Hi all , whats the best float for rubbing up sto basecoat on a thin coat system please .