hi guys I'm looking for a time served plasterer in rochdale, the job is a big lounge, two rooms converted into one it is a full reskim ceilings and walls it is three days work for 300 cash get in touch 07851382676 internal angles must be bang on straight and edges all crisp. doing job once must...
hi guys I'm looking for a time served plasterer in rochdale, the job is a big lounge, two rooms converted into one it is a full reskim ceilings and walls it is three days work for 300 cash get in touch 07851382676 internal angles must be bang on straight and edges all crisp. doing job once must...
Hi guys I am trying to look for someone to help me skim my house top to bottom all hallways and ceilings I have level 1 city and guilds but no experience if there is any other student out there or someone who has recently qualified who fancies having a go your more then welcome i wil also pay you
Surveyor specified "remove all defective render" when asked for more details said it should have a bellcast bead and not be rendered to ground all way round house as it is(was). So now I have removed the render to well above the dpc the gap is over 50mm from the ground to the dpc it's probably...
Great so I will paint the block with black bitumen once I have wire brushed it clean, then I will mount the bellcast bead with spirit level above dpc cement course, then I will render above the bead with two coats scratch and final (can I get away with ten mm in one coat) or will it all fall...
ThAnks for the easy explanation, so it's skirting basically made of cement. So my block at the moment is bare shall I stick to painting it with black bitumen
could you explain what the plinth is? sorry for the dumb questions , so i am going to drill 6mm holes at each mark on the bead and then screw the bead onto the wall above the dpc which is in the cement course below the air brick. so i was going to clear the cement course and attached to the...
the dpc is in the cement below the air brick i have just cut above the air brick as the bellcast bead is quite big and i didnt want to have to cut the render above the dpc a few times to let the bead fit, since this morning i have removed any excess cement on the blocks and it is now looking...
Hi guys just wanted to ask you a question about rendering, my old render was all the way to the ground! so I have cut it above the damp proof course,
and now I just want confirmation of the following
1. that i should render below dpc first, 3:1 scratch coat, then finishing coat 4:1 and then I...
you have definitely tried and tested this method haven't you.... you seem very sure it will work, hmmm thats another way to get my p45 but i prefer doing a bad job and being fired rather then signing the register you have to every week ;-)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.