Recent content by Mr White 1

Think the best one I had was around 18 months ago. Got him from college, lasted 6 weeks and went back to college. Reason - He was better off in college as his mum could get benefits due to him being classed as “still in education”

It’s shocking at the moment. Interviewed 7 a week ago and half of them had not even looked into the trade or the website. One lad, 20, when asked about wages said he wasn’t bothered what the pay was as long as it was more than his current job…. Which turned out to be fitting wheels to wheely...

I usually try and take on young lads close to where me and the other lads live. We’ve really struggled over the last 3 years and have gone through 13-15 who leave after a few weeks / months for a variety of reasons. If they drive already it’s difficult as they want to start on half decent...

Thanks for putting the video up also.

We’ve used high polymer basecoats in the past that can be difficult to spray and use, FASSA S650 and A96 spring to mind. Then we’ve had other like X32 ans Johnstones HP which seem to be easier.

What does it spray like, rub up like? It looks like the video with the MTEC has an external compressor, I’m not overly familiar with MTECs mind as we run a Ritmo.

Thanks, to be honest I’d rather hear from those that have used it rather than sell it. I cannot seem to find much information online other than the odd video and merchants that sell it. Thanks again.

Anyone used this or got any experience using it? Comes in grey or white. Any feedback appreciated.

Johnstones silicone enhanced is not full silicone, in fact it’s got very little silicone in it and is made up of cheap glues and binders. To spray it, it needs diluting quite a lot to break down the binders, the problem with that you end up with a very weak and thin product. Full Silicone...

Spraying 1.5mm We tend to spray a pass then drop back with a second light pass. Credit to Dave in Barnsley (some will know him) as he gave us a lot of this info and helped us get going.

Over the years we’ve tried all sorts of ways to spray silicone. The open top gravity fed hopper gun, as said above, leaves a heavy texture which I was always worried would be pulled. You’ll need a decent compressor. The Bennu gun is decent but very expensive for what it is, you could probably...

It seems I don’t need to dig out any old bank statements - https://corksoluk.com/approved-applicator2/corksol-approved-applicator/

this is after 2 or 3 coats.

As you can see from the above it was £1152 for 6 tubs. The email is there asking for the yearly membership money. If you like I’ll dig out my old RBS statements and show you where i transferred £1200 over to them for the ‘course’