cove tool

[S a plastering]

has anyone tried them rubber cove tools they sell at refina ive got to run one in next week its just an oversized normal coving about 8inch just wondering if they are any good or any other suggestions for getting the shape thanks

 

[RemovedMonkey]

there nice tools iv seen them on the site werth the money

 

[ADS]

a small joint rule and a long busk are the best tools imo.

 

[Pug]

always scribe mine now (after being shown how to do it on here. cheers guys!)

 

[S a plastering]

always scribe mine now (after being shown how to do it on here. cheers guys!)

im running it in mate

 

[nelly]

I f*ckin hate coving

 

[S a plastering]

I f*ckin hate coving

i hate plastering full stop lol

 

[lewisricekrispy]

Cut off a small piece and put it up to your corner, marking both top and bottom. Repeat on other part of corner. Measure distance to where both corners meet (at top). Get your coving and come in 10mm. Mark measurment on top lip. for internal put ceiling edge to bottom. Line up top and bottom and add a 45 degree mitre to it.
If done correctly you should end up with that weird curved shape

 

[mistersmooth]

theyre great for mitres-put a bit of splodge on em and push it into your corner-you can virtually use em to go up and down your mitres theyre that flexible

 

[S a plastering]

theyre great for mitres-put a bit of splodge on em and push it into your corner-you can virtually use em to go up and down your mitres theyre that flexible

do you mean run it with it thats what im doin this week its a cast coving