K - rend

[Putzmiester]

Hey guys anyone put e grade through a g4 ?
if so any tips got 2500m2 to do :RpS_scared:

 

[Plasterers1StopShop]

Hi mate, you will be fine with your D,6-3 P1 - a spray jet is an extra you could go for. This will disperse the water and allow for a slightly better mix

 

[keithuk]

Hey guys anyone put e grade through a g4 ?
if so any tips got 2500m2 to do :RpS_scared:

Nice m2 mate ,good to see your busy :RpS_thumbup:

 

[PFTwales]

Use a d 4-2 clampable. K rend silicone will go through the G4 very well. Set it at about 12 bar and try maintain the 12 bar everytime you pump test. You will get 25+ ton and should see a saving on generator fuel because the machine will not be labouring as much.

 

[PFTnorthern]

D4.2 will be your best option runs a treat no problems .

 

[plasterjfe]

we spray it with a 4-2 no probs and no jet.

just think at 0.8m2 per bag how many more bags you will need on a job that size compared to another, the money saved on that size would be magic in your ar5e pocket

 

[Putzmiester]

Thanks guys

 

[Putzmiester]

sorry guys may seem dumb but what is a spray jet??????????????????????????????

 

[PFTwales]

a fitting with a reduced hole to form a jet rather than a stream of water that goes between your water feed pipe and the mixing chamber

 

[Rigsby]

https://www.youtube.com/watch?v=1fgA5emu5oI

 

[PFTwales]

there you go! nearly 30 m pipe and not even 10 bar

 

[Putzmiester]

Wow it seems to pump nice quite looking forward to doing it now

 

[UKPlasteringmachines]

he's using a 35mm pipe then onto a 25mm pipe that always helps as well to keep back pressure down