New to the forum - Hello Everyone

Status
Not open for further replies.
AntJones

AntJones

Member
Hello everyone

Machine plastering tips needed
I've been getting a lot of shoulder joint pain over the last 6 months (usually while trowelling up the second gauge) i think its finally giving in - . So to help easethe situation - I have decided to get a plastering machine.
I haven't used one since when I did a couple of years in Germany back in the nineties -PFT G4 then. So I'm rusty:RpS_unsure:

I want use it wherever I can to take pressure off the old shoulder for internal solid work and render systems.

I'm looking for advice on set up preferences ,rotor/stator requirements and anything I should avoid doing.
Thanks Fellas
 
Welcome to the forum , did a few years in Germany my self back in the day, good luck with your machine search, there is a guy called Goody on here selling a ritmo set up
 
Or have a chat with Les at PFT northern ,helped me out ,loads of guys here will advise you ,best of luck
 
Thanks for that.
Been in touch with Goody.
I'm sure a few challenges lie ahead with this.
I worked in Hannover area from 93 to 96. more good times than bad. Great beer there aswell.
 
Status
Not open for further replies.
Back
Top