PVC Render beads

Status
Not open for further replies.

User________removed

Private Member
Trying to locate some 15-16 mm PVC corner blocks, If that makes any sense. They basically sit at damp level and click into the stop and corner bead leaving it nice and tidy. "No bell cast / drip being used"

Ive seen them a good while ago but cant remember where, Render-plas rings a bell but just been on the site and no joy.

Hopefully this makes sense, If anyone's used them or has a contact i would be grateful of a link.

Cheers AB
 
I Quite like them makes it a bit easier but am a bit worried if the corner took a knock the whole lot would fall off.
 
Used on the outside, they are basically the most reasonable pellets you can buy. For plastering and dry lining, they are similar in cost to galvanized precious metal pellets, but with far less waste from informal harm on website and on the road, and zero discoloration during long blow drying out periods, PVC pellets are the best value choice.
Professor Stanley Unwin lives agein.
 
Used on the outside, they are basically the most reasonable pellets you can buy. For plastering and dry lining, they are similar in cost to galvanized precious metal pellets, but with far less waste from informal harm on website and on the road, and zero discoloration during long blow drying out periods, PVC pellets are the best value choice.
Professor Stanley Unwin lives
 
Status
Not open for further replies.
Back
Top