Render
- Thread starter MIXERMAN
- Start date
Vincey
Private Member
Mate I did this last year on someone else’s job it was ok but after I just thought should of just used the ocr as a scratch coat instead as I enjoy using that material
smoother09
Well-Known Member
What wrong with s/c all the way through... don’t understand the question
Agree better off sticking to one system whatever it may be b
essexandy
The Lake Governor
Can't you get a nice even finish with sand and cement? If not why not?
Vincey
Private Member
I set at 250 mate , have run it at 200 before but Tbf was to stiff
Cheers mate
I was trying to run it at 200 wanted it to pull in quicker, it must be pulling too many amps keeps tripping
Vincey
Private Member
Agree mate good luck with it are you spraying it now for an overnight?Cheers mate
I was trying to run it at 200 wanted it to pull in quicker, it must be pulling too many amps keeps tripping
I've got two plots to do with detached garages, I've been beading up and masking finished early so I've had a blast on the garage to get settings right it's going to be overnight mate
choppa
Well-Known Member
K mix is nice to use.
themucky1
Well-Known Member
Did you sort out the electrocution problem?Cheers mate
I was trying to run it at 200 wanted it to pull in quicker, it must be pulling too many amps keeps tripping
Yes mate marigolds seem to have done the trick for now
Seriously though I'm going to get it sent off when I can do without it, although the weather is s*** there's hardly a couple of days go by where I haven't needed it,
Baumit don't f****** like me trying to rip me off