Morning all! Just signed up so go easy on me...
I'm just about to render the back of my house and will be using k-rend. I'm not in the plastering trade but I am quite capable when it comes to building work.
My problem is that we would like to remove the cladding and replace it with render. I first thought that there would be block work behind the cladding but it lightweight block only, and after you remove the cladding there is about a 100mm recess across the back of the house that would need to be filled to being it out level with the doors down below.
What are my option? Should I just render straight over the lightweight block and construct an edge, or I was think about boarding it out some how. Maybe insulation board then render over the top.
Hope this make sense, will try and upload some photos as well.
Thanks in advanced!
I'm just about to render the back of my house and will be using k-rend. I'm not in the plastering trade but I am quite capable when it comes to building work.
My problem is that we would like to remove the cladding and replace it with render. I first thought that there would be block work behind the cladding but it lightweight block only, and after you remove the cladding there is about a 100mm recess across the back of the house that would need to be filled to being it out level with the doors down below.
What are my option? Should I just render straight over the lightweight block and construct an edge, or I was think about boarding it out some how. Maybe insulation board then render over the top.
Hope this make sense, will try and upload some photos as well.
Thanks in advanced!
Last edited by a moderator: