Selfbuilder999
New Member
Hi all,
I've been priced into having a go at doing a section or two of scratch back external render ... so not plaster, but have a feeling someone on here will be able to advise.
There are two external curves of 300mm to do.
What I'm after is a bead for the base line that will curve, or can be cut into so it will curve.
(Attached photo shows one of these in place elsewhere, from umderneath)
So far I've seen "arch beads" for internal curves ... Would these go the other way?
No need for a bell cast or drip edge as the face being rendered overhangs the wall by several centimetres.
All suggestions welcome of course (except "pay up for a pro" ;-) ...)
I've been priced into having a go at doing a section or two of scratch back external render ... so not plaster, but have a feeling someone on here will be able to advise.
There are two external curves of 300mm to do.
What I'm after is a bead for the base line that will curve, or can be cut into so it will curve.
(Attached photo shows one of these in place elsewhere, from umderneath)
So far I've seen "arch beads" for internal curves ... Would these go the other way?
No need for a bell cast or drip edge as the face being rendered overhangs the wall by several centimetres.
All suggestions welcome of course (except "pay up for a pro" ;-) ...)