prb render

Share this page

J

jumbobroon

New Member
hi hoping to get some advice ,client wants prb mexico colour applied to small extension wall the pattern he wants is crushed .thats it mexico colour crushed pattern anyone done this and advice on how to go about it cheers trying to get photos of this to send on.
 
Nos Vamos Viva Mexico GIF
 
If we are talking about the same finish. We rendered the wall leaving plenty of trowel lines. Then with a slurry mix threw lumps at the wall with a grass brush. Then run a trowel over the lumps [Crushing] to give the appearance of the render falling off.
Do a test panel on a piece of render board for the customer to make sure .
 
malc said:
If we are talking about the same finish. We rendered the wall leaving plenty of trowel lines. Then with a slurry mix threw lumps at the wall with a grass brush. Then run a trowel over the lumps [Crushing] to give the appearance of the render falling off.
Do a test panel on a piece of render board for the customer to make sure .
Click to expand...
You've just described half (being generous) the spreads on here trying to plain faced finish.
 
malc said:
If we are talking about the same finish. We rendered the wall leaving plenty of trowel lines. Then with a slurry mix threw lumps at the wall with a grass brush. Then run a trowel over the lumps [Crushing] to give the appearance of the render falling off.
Do a test panel on a piece of render board for the customer to make sure .
Click to expand...


 
malc said:
If we are talking about the same finish. We rendered the wall leaving plenty of trowel lines. Then with a slurry mix threw lumps at the wall with a grass brush. Then run a trowel over the lumps [Crushing] to give the appearance of the render falling off.
Do a test panel on a piece of render board for the customer to make sure .
Click to expand...
Sounds like my float finish …
 
You must log in or register to reply here.
Top