M
malc
Latest activity Postings About
-
-
Mmalc replied to the thread Hairline Ceiling cracks Fermacell Plasterboards.The best advice would be phone a plasterer!
-
MIf you can’t get away with a bit of filler and sanding then yes you can pva and go at it again but put a few coats of pva on because...
-
Mmalc replied to the thread Why is SBR not killing suction.Tell the customer not to slam the door as it may bring the ceiling down!
-
MThere’s no way you’re finishing limelite the same day!
-
MRather eat dogshit thsn entertain that
-
Mmalc replied to the thread Social Housing Work.Nice house, must have a decent council in Prestbury!
-
MWait - He's busy typing, Yep, He's starting another thread, It's going to be about........ A hearth.
-
Mmalc replied to the thread Best product for concrete.Don't use a cement grout on the concrete ,that idea died out about 40 years ago. The grout dries out quicker then the screed leaving the...
-
Mmalc replied to the thread Roughcast Issues.The walls are saturated. You are lucky that you have not lime bloom as well.
-
MHi all I hired someone to fix a damaged area of roughcast on front of my mum's house and I explained I was worried the cement colour...
-
Mmalc replied to the thread Hairline over all walls.Woodchip paper!
-
Mmalc replied to the thread Overboard or replace damaged artex ceiling.The problem with a replacement for your ceiling is the mess and the loss of your loft insulation. You will need the landing ceiling and...
-
MA lot of spreads, myself included, prefer/insist on tacking the ceilings ourselves. It is very, very rare that a DIY person will fix the...
-
MHave you got a secret to tell Aiden ? ;)
-
Mmalc replied to the thread Rendering Help.Put some photos of your property up. Are there other properties in the area in similar condition?
-
Mmalc replied to the thread Advice please on re rendering a property built late 1700s.It is impossible to know the way forward without seeing the condition of the external.
-
Mmalc replied to the thread Lime Plaster - confused.If I was a midlands chap , I would choose the Kia! :risas:
-
MMiddle
-
Mmalc replied to the thread Rendering Help.Your timber frame building had a very poor spec for the rendering. I would remove all render, eml, and ply. If the condition of the ply...
-
MHillside vids were hilarious, but sadly deleted. Kirk Giodiarrhoeanio's vids were gold, especially the shoutout from across the pond to...
-
Mmalc reacted to Spitandpolish's post in the thread SBR Peeling off wall (substrate and old finish) with
Funny.
As soon as the van door opened ! :confused: -
Mmalc replied to the thread Curved Bellcast bead?.That is the method we used. Give the bell cast batten a coat of shuttering oil so that it drops clean.
-
Mmalc replied to the thread SBR Peeling off wall (substrate and old finish).After the first minute.
-
Mmalc reacted to Steve Brown's post in the thread SBR Peeling off wall (substrate and old finish) with Like.
I rarely use SBR internally mainly stick to good old PVA and prefer to plaster when it's dried. But when I use SBR I never plaster when...
-
Mmalc replied to the thread SBR Peeling off wall (substrate and old finish).Never use SBR on internals. Only on external render or floor screeds. Material must be applied when SBR is wet.
-
-
Loading…
-
Loading…