Cut new opening in wet dash concrete block wall

[Rosser]

Hi Lads,
I have just had to cut a new opening in a wet dashed concrete block wall,
I am at a bit of a headsratcher on how to finish new ingoes/reveals where the new smooth rendered ingoe/reveal finishes at the front face when it meets the existing wet dash at 90 degrees.

Any ideas much appreciated

 

[FreeD]

Phone a renderer and get them round? Few ways to do it.

 

[Stewie03]

@themucky1

 

[S a plastering]

Yes

 

[Rosser]

Yes

I am a renderer
Would normally put a cement band around new opening but that’s not an option this time

 

[FreeD]

I am a renderer
Would normally put a cement band around new opening but that’s not an option this time

Whats the opening for? window/door? Just pass the buck onto the fitter. We know what a lovely job they will make of it.

 

[Rosser]

Whats the opening for? window/door? Just pass the buck onto the fitter. We know what a lovely job they will make of it.

Haha, yea good idea but the fitters were “botchit and scarper”
It’s a doorway

 

[themucky1]

Hi Lads,
I have just had to cut a new opening in a wet dashed concrete block wall,
I am at a bit of a headsratcher on how to finish new ingoes/reveals where the new smooth rendered ingoe/reveal finishes at the front face when it meets the existing wet dash at 90 degrees.

Any ideas much appreciated

Yes

 

[ChrispyUK]

clad it

 

[Rosser]

clad it

Decent shout mate but it’s an industrial building with a few openings on same elevation and needs to match as close as possible

 

[FreeD]

Decent shout mate but it’s an industrial building with a few openings on same elevation and needs to match as close as possible

Put a photo up I’m sure we can find a solution