Done first ever float coat today

Monkey Boy

Monkey Boy

Well-Known Member
Newbie to rendering here (like a little kid looking for praise from his Daddy with this post)
Done this float coat today. I’m happy with it tbh. Never done it before nor seen it done. Worried it might fall off in a week cos I’ve made some bad decisions and my scratch coat was crap.
Yes I know that brick work below the damp course looks dodgy - it ain’t as bad as it looks...

Two questions:
1. Do I need to spray it over to slow the cure time down? (5/1/1 mix 9 degrees out now dropping to 2 tonight...)
2. How do you float up over them bell end beads? Along the length or across them? I spent ages on that bit and made the lot look worse probably

I’m ready to be ripped...
Done first ever float coat today
 
Mist it with water will help it cure and not dehydrate. We just f**k off though and invoice. Looks like you did a nice job though, well done.
 
Good effort.
Take time to check out bell drip. There’s lots of ‘looks’ but yours ....well....
As has been said, misting help.
Bag up those bricks......google it.
Keep it up.
 
Monkey Boy said:
Newbie to rendering here (like a little kid looking for praise from his Daddy with this post)
Done this float coat today. I’m happy with it tbh. Never done it before nor seen it done. Worried it might fall off in a week cos I’ve made some bad decisions and my scratch coat was crap.
Yes I know that brick work below the damp course looks dodgy - it ain’t as bad as it looks...

Two questions:
1. Do I need to spray it over to slow the cure time down? (5/1/1 mix 9 degrees out now dropping to 2 tonight...)
2. How do you float up over them bell end beads? Along the length or across them? I spent ages on that bit and made the lot look worse probably

I’m ready to be ripped...
View attachment 49041
Click to expand...
if you've done that today I would be checking the weather forecast for over night.
 
Monkey Boy said:
Newbie to rendering here (like a little kid looking for praise from his Daddy with this post)
Done this float coat today. I’m happy with it tbh. Never done it before nor seen it done. Worried it might fall off in a week cos I’ve made some bad decisions and my scratch coat was crap.
Yes I know that brick work below the damp course looks dodgy - it ain’t as bad as it looks...

Two questions:
1. Do I need to spray it over to slow the cure time down? (5/1/1 mix 9 degrees out now dropping to 2 tonight...)
2. How do you float up over them bell end beads? Along the length or across them? I spent ages on that bit and made the lot look worse probably

I’m ready to be ripped...
View attachment 49041
Click to expand...
I’d be more worried about your shed falling down then the rendering falling off, did u run out of muck when laying the brick
 
The Hobo said:
hawk; sorry don't understand?
Click to expand...
Dragged my hawk up across the two beads on that skinny strip on the right intended as a straight edge. Realised curved corners on hawk were sinking it in below bead level so used trowel instead..
Thanks for looking anyways
 
Monkey Boy said:
Dragged my hawk up across the two beads on that skinny strip on the right intended as a straight edge. Realised curved corners on hawk were sinking it in below bead level so used trowel instead..
Thanks for looking anyways
Click to expand...
looks like you don't know about the long standing hawk or handboard debate on here/job looks ok to me pal
 
You must log in or register to reply here.

Share this page

Back
Top