EWI - Tools for sale

Status
Not open for further replies.
L

lullaby

New Member
Hi Guys,

I have for sale the following two tools (EPS cutter and pumping machine) both 110V and perfect working condition.

The hot wire is 6 months old. I think is a German product but not 100%
Has two parts: The main cutter and the 3D creative frame
The main cutter can cut:
- cutting length 132 cm
- up to 38 cm thickness
- side angle 0-90 degree (the horizontal stand)
- cutting angle 15-145 degree (if you need a samph cutting)
The attachable 3D creative frame:
- cutting length 41 cm
- up to 27 cm thickness
Spare wires for both cutter
Selling price: 800 pounds

The pumping machine.
It is an INOMAT M8 peristaltic feeding pump in perfect working order. The material hose and the spraygun are missing.


Link Removed

Selling price: 900 pounds

If interested contact me: [email protected]

The tools are in Leicester - pick up from here.
 
lullaby said:
Hi Guys,

I have for sale the following two tools (EPS cutter and pumping machine) both 110V and perfect working condition.

The hot wire is 6 months old. I think is a German product but not 100%
Has two parts: The main cutter and the 3D creative frame
The main cutter can cut:
- cutting length 132 cm
- up to 38 cm thickness
- side angle 0-90 degree (the horizontal stand)
- cutting angle 15-145 degree (if you need a samph cutting)
The attachable 3D creative frame:
- cutting length 41 cm
- up to 27 cm thickness
Spare wires for both cutter
Selling price: 800 pounds

The pumping machine.
It is an INOMAT M8 peristaltic feeding pump in perfect working order. The material hose and the spraygun are missing.


Link Removed

Selling price: 900 pounds

If interested contact me: [email protected]

The tools are in Leicester - pick up from here.
Click to expand...

Will the INOMAT M8 peristaltic feeding pump spray skim? And what size of gen do u need to run it
 
@johniosaif I didn't mind doing it at all but I've never been asked for it up until now so I'm not expecting a sudden rush.
 
Last edited by a moderator:
essexandy said:
@johniosaif I didn't mind doing it at all but I've never been asked for it up until now so I'm not expecting a sudden rush.
Click to expand...
I have not done it either,wouldn't mind knowing how to do it properly, skimming has taken over my life now,doing a staircase today which had stone steps,brand new and delicate,covered with hard board and celotex for protection which is fine but there was beads leaving a 3mm gap on each step all around,nightmare, I said we can't guarantee what I can't see..
 
@Danny thing is if you're busy anyway what's the point in pushing a system that there are loads of people already doing it for less than I'd want. There's a guy on here offering EWI work for £XXm2 and we'll get that for a normal two coat render.
 
Last edited by a moderator:
essexandy said:
@Danny thing is if you're busy anyway what's the point in pushing a system that there are loads of people already doing it for less than I'd want. There's a guy on here offering EWI work for £XXm2 and we'll get that for a normal two coat render.
Click to expand...

Fair enough :RpS_thumbsup:
 
You know that nothing is funnier than a psml wall, and frankly if you didn't then you shouldn't be plastering.
 
EWI - Tools for sale
EWI - Tools for sale
 
Status
Not open for further replies.

Share this page

Back
Top