hello peeps.

[charente]

ok,i was in a house doing a wall as you do using the multi finish,and im at the end stage,sprayed a little water and off i went ,then as if my trowel had abs braking on it ,it started stoping and starting leaving lines on the plaster,any clues why:RpS_crying:

 

[Fatarm]

Okey dokey. Eddie, mabye your trowel ran out of petrol! or it needs a service:RpS_biggrin:.

 

[charente]

NO,fatarm,it runs on diesel,goe's further,so there.

 

[jcrplast]

Use slightly more water, and dont apply so much pressure.

John will tell you, its all in the wrist.

 

[Minh]

Did you open up the trowel too much? Too much pressure? Surface not sufficiently flat for a wet trowel?

In future, tilt the trowel at a slight angle as this will relieve some pressure on your wrist and reduce the amount of effort required. I like to call it bowing the trowel

 

[ljmetcalfe]

ya left it too long should of got on it sooner piss it when thru when that happens.