ok,i was in a house doing a wall as you do using the multi finish,and im at the end stage,sprayed a little water and off i went ,then as if my trowel had abs braking on it ,it started stoping and starting leaving lines on the plaster,any clues why:RpS_crying:
Did you open up the trowel too much? Too much pressure? Surface not sufficiently flat for a wet trowel?
In future, tilt the trowel at a slight angle as this will relieve some pressure on your wrist and reduce the amount of effort required. I like to call it bowing the trowel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
