Machine Applicators required

Status
Not open for further replies.

Plasterers1StopShop

Well-Known Member
An opportunity for Machine Plasterers

Newton Waterproofing Systems and Plasterers 1 Stop Shop - PFT Central in partnership are seeking experienced spray contractors to train up to become approved contractors for the external cork render/insulation system “Diathoniteâ€￾.

This unique cork based thermal plaster system gives excellent thermal and acoustic properties and has very strong green credentials.

Please visit our website for information on the system Diathonite - Insulation Plaster | Newton Waterproofing Systems

If you would like to become an applicator please contact Ryan at PFT Central: [email protected] or call 01242 236699.

Places for applicators are limited so please apply quickly.

What does the training include:

The cost of the training is: £450.00 per person + Vat.

This will include: Accommodation, breakfast, light lunch, Tea & Coffee

Day 1:
Product Introduction - Pump Introduction - Pump set-up - First coat application - Machine Clean Down - Q & A

Day 2:
Pump set-up - Second Coat Application - Material Finishing - Top Coat Application - Clean Down - Q & A
On completion of the course you will be presented with a Newton / PFT Central Specialist Contractor Certificate

What will Newton and PFT Central do for you:

Although the training costs do seem high, it is certainly worth it. We currently have 3 approved applicators who are flooded with work. Newton have been working very hard marketing this product and it is becoming extremely well known

Both Newton and PFT Central will pass leads your way. Newton will also aid you in your marketing of the product. PFT Central will provide full machine support whenever needed. Back-up machines are readily available.
Newton have been working extremely hard with this product and many architects are specifying it - the jobs are more Bespoke.

We will also offer an incentive if you find your own work. There will be two rates which we supply material out to you, the price if we pass you the work, the price if you find the work. This gives more of an incentive to be active in looking for the work and advertising it on your website.

If you have any questions please do not hesitate to get in touch

 
Will sort the prices etc for you Monday. Will give you a call about it as I don't want to be putting the applicator prices etc online


I'm using The Plasterers Forum Mobile App
 
The gears an absolute nightmare to use good luck, hopefully it was just me
is there much call for it it costs a fortune?
 
Hi Dan,

Yes it can be hand balled. But putting it on 100mm by hand maybe a little bit of a struggle and you would clearly have to charge loads to do it so may not be competitive compared to machine guys



I'm using The Plasterers Forum Mobile App
 
Forget putting it on by hand you'll waste more than you use and unless you get the mix spot on you won't get more than 10mm per coat, we used it on a church in portishead Ryan the only way I could get a finish was I sectioning it off beads then it was finished with lime putty
it was only reveals so hand applied but I wouldn't do it again on a half decent area without a machine, you deffo need depth beads and I'd still I section and try to close it in with a float the next day if it was the finish it's a mare slumps etc
 
Status
Not open for further replies.
Top