Paddle stuck to mixer

[craigEEE]

On a refina drill, struggling to get it off with spanners, any tips?

 

[kebab king]

Soak it in hot water. May expand the metal. Like applying heat to seized metal

 

[S a plastering]

I use an adjustable spanner on the machine end mat lie it he machine on the floor so the spanner rests on the floor then with both hands hold the bottom of the paddle an try an twist it off that way

 

[CeeVee]

Smash the spanners with a hammer

 

[JessThePlasterer]

Lube

 

[craigEEE]

Smash the spanners with a hammer

Tried this, its f**k**g welded on

 

[Simon85]

Lube

 

[S a plastering]

Can you not get too a vice mate an clamp the machine chuck end then try an pry it off somehow

 

[Danny]

bigger bar more leverage or apply heat

 

[Dr.B]

Are you turning it the right way


Sent from my iPhone using Tapatalk

 

[Vincey]

Sodium bicarbonate and get yourself a Collomix cleaning bucket , it won’t happen again then

 

[JessThePlasterer]

Stick it in a vice, plug it into the wall, turn it on on spin round on the end of it!

Weeeeeeeeeeeeeeeeeeeeee!!!!!!!

 

[Simon85]

Stick it in a vice, plug it into the wall, turn it on on spin round on the end of it!

Weeeeeeeeeeeeeeeeeeeeee!!!!!!!

Jeez youre a wild one you are

 

[Gibbo]

Brick acid where the two meet

 

[Dropsalot]

man up and undo it......wuss.....

 

[Danny]

you could put two spanners on it and then put both spanners in the jaws of a vice and wind the vice

 

[WWBRenovation]

Put a torch on it for about 30 seconds, moving round constantly, then two wrenches one on the floor the other one turn above and step on the top one. Otherwise do some pull ups and press ups and come back to it a month, )

Sent from my MotoG3 using Tapatalk

 

[stuart23]

Remember it's a reverse thread on it! I spent ages trying to get mine before realising I was turning it wrong way lol

 

[algeeman]

il sort it for £300.
£350 if its a weekend job.