Plaster moulding rebuild

[Zigshar]

Hi,

Trying to figure out the best way to rebuild plaster crown moulding after recent beam installation. Any help would be appreciated thanks

 

[Spudknit]

@Casper

 

[Dollar]

Shame really , no need to have that issue to /install beam .
You will need a template & a local company to make a piece up to match ......

 

[Retired Spread]

any good spread will be able to repair that without the need to go to a specialist mouldings company.

 

[Monkey Boy]

That needs running along the beam too
You can’t just terminate it grrrr

 

[puddove]

cut existing cornice square, offer up a piece of card and draw round cornice
from drawn template construct a direct mould, run down on the bench with a backboard at 90 degrees to imitate the ceiling and wall angle. you can core out with damp sand to reduce weight.
(this is a easier than running insitu if you have no experience.

 

[MakeItSmooth]

1) Squirt PU foam in the gap.

2) Crudely carve with a kitchen knife.

3) Paint.

4) Congratulate yourself on a job well done.

5) The next day, do as yer missus told you right from the outset, and pay a plasterer to do the job properly

 

[jamesthefirst]

Square the cornice off using a multi tool, measure distances from wall and ceiling. Go to cornice site on interweb and you should be able to buy a 2.4 m length that matches what you have. Or give me a call im in your area and ill fill it with easi 20 filler

 

[Dollar]

New cornice needed & /as @Monkey Boy
Pointed out you will need to / meet adjacent wall with cornice ...