Rendaid too thick?

[PlasterCraftDundee]

First time using rendaid I put it on about as thick as I put multi on but when I rollered it it seem to leave a really thick stipple. I'm thinking I maybe mixed it s bit watery or went over it with the roller too soon. Will I still get 1m2 out a bag. Don't worry it's a good friends house and not a paying customerLink Removed

Sent from my SM-G930F using Tapatalk

 

[Dansouthcoast84]

i scratch comb if its going up say 5mm.

or roller it if its a tight stsbalising coat

 

[Djr]

Yes we normally roller it on .especially of we're supplying it

 

[Danny]

that is quite thick though Will be fine I am sure

 

[PlasterCraftDundee]

I think it turned out ok on the end. First time using Weber and only second time using mono. Learnt quite a bit not exactly perfect to be honest there was one or two hollows i only noticed once I scratched back and the sun moved. Found smaller areas like this a lot harder to get flat, maybe need to buy a smaller spat or straight edge?Link Removed

Sent from my SM-G930F using Tapatalk

 

[zombie]

I think it turned out ok on the end. First time using Weber and only second time using mono. Learnt quite a bit not exactly perfect to be honest there was one or two hollows i only noticed once I scratched back and the sun moved. Found smaller areas like this a lot harder to get flat, maybe need to buy a smaller spat or straight edge?Link Removed

Sent from my SM-G930F using Tapatalk

Don't fret fela people will only notice the minging block paving anyway!!! Lol

 

[Danny]

I think it turned out ok on the end. First time using Weber and only second time using mono. Learnt quite a bit not exactly perfect to be honest there was one or two hollows i only noticed once I scratched back and the sun moved. Found smaller areas like this a lot harder to get flat, maybe need to buy a smaller spat or straight edge?Link Removed

Sent from my SM-G930F using Tapatalk

looks better than some of the houses round my way

 

[El plastering ltd]

I got a house to do thinking to rendaid first coat spraying in with a hopper and then k1 spray over the top as the guys want k rend can I do this as to trowel on hp12 it would take longer an slightly more expensive?
Cheers guys