Bounce it off your forehead a dozen times.what's the best way ,got a bad Nick in it on Friday ,f**k**g boarders not putting screws in right,
Concrete block and a lump hammer. Make sure you put it flat.what's the best way ,got a bad Nick in it on Friday ,f**k**g boarders not putting screws in right,
Load of b*ll***s ain’t it mate!Been plastering over 30 years,,,,
Still doesn’t know how to get nics out a trowel!!!Aye whatever!!
Diamond stone then a bit of emery clothwhat's the best way ,got a bad Nick in it on Friday ,f**k**g boarders not putting screws in right,
Grinderwhat's the best way ,got a bad Nick in it on Friday ,f**k**g boarders not putting screws in right,
Good see yer back on u still fan of Refina spatCan use an old piece of mortar to rub up and down the damaged edge. But as sand cement is rare as hens teeth on site these days use the oil stone method as mentioned above. Might be an idea to dry bum whoever responsible for the boarding while your at it too??
Was never a fan of Refina spat the eze one. But been using the blue speedskim one now for quite sometime. I use the eze if I need some extra time. Hope your in fine fettle too pal??Good see yer back on u still fan of Refina spat
how much and were fromDiamond chisel block always leave one in my tool bag they are the bees knees
Depends how many diamonds are on it.how much and were from
Not bad at all hopefully off on holiday in August with the familyWas never a fan of Refina spat the eze one. But been using the blue speedskim one now for quite sometime. I use the eze if I need some extra time. Hope your in fine fettle too pal??
how much and were from