Is s**t advice for me then lol
Skim over Artex query
- Thread starter Ralphyboy
- Start date
D
Deleted member 40920
Guest
Let's skim it - hope the artex doesn't fall off or the board crumble, if it does cut it out and patch it, wait for the rest of the PVA to dry, then skim it, hope for no other problems, possibly have to stain block it afterwards. OR could go to all the hassel of putting one bit of board up and do a proper job
D
Deleted member 32554
Guest
If going for the chance option
Allow first pva to dry properly.
Trowel as little and lightly as possible , the moisture from skim can travel through by the time your trowelling up and the artex can delaminate
Get customer to paint with Zinn after
Decent vent fan ( need a decent gap under door ) and check insulation above
Allow first pva to dry properly.
Trowel as little and lightly as possible , the moisture from skim can travel through by the time your trowelling up and the artex can delaminate
Get customer to paint with Zinn after
Decent vent fan ( need a decent gap under door ) and check insulation above
Exactly.. plastering easy just people make it complicated I'm turning in Churchill of plastering lol. Nother saying I like from him. Y stand when you can sit. Y sit when you can lie down
Skullduggery
Member
Haha...i like that.
Stevieo
Royal Spin Doctor
And some people on this site don't know the meaning of professional.
f**k, they couldn't even spell professional.
The thick c**ts.