Solo lime finish

S a plastering

S a plastering

Private Member
Has anyone used this got some too do over warmshell insulation which is stuck on top of nhl 3.5 not really used the finish before just wanted a run through thanks
 
l*m*-g***n solo?
Iv used a fair bit, it’s hard work drags like f**k.
Best way I found a tight coat then drop back and second coat, I use a 600 spat to flatten in then 16” float sponge then last off hard trowel
 
Tinytom said:
l*m*-g***n solo?
Iv used a fair bit, it’s hard work drags like f**k.
Best way I found a tight coat then drop back and second coat, I use a 600 spat to flatten in then 16” float sponge then last off hard trowel
Click to expand...
OK cheers I'll give that a go it's on top of warmshell which has to be fully meshed in first pass
 
Think that was it. . Not 100 percent but think we 2 coated with it .
 

Attachments

  • Solo lime finish
    Screenshot_20230706-181422_Samsung Internet.jpg
    338.7 KB · Views: 96
John j said:
Think that was it. . Not 100 percent but think we 2 coated with it .
Click to expand...
That’s what Iv used a few times now usually over nhl3.5 scratch but also gone over ultra base coat, never had problems with it bubbling just give background a really good soak
 
Yea that's the one this is grade 2 listed so on stonework is nhl3 with grit sand then then a breathable 2 inch thick fibre board with the solo on top
 
You must log in or register to reply here.

Share this page

Back
Top