The prb

[Vincey]

I got a job with another lad I know he’s got a pallet of prb , does anyone use accelerator with this to get the same day finish, normally use Weber which is fine but not sure about this prb,
Thanks

 

[Plasterers1StopShop]

I got a job with another lad I know he’s got a pallet of prb , does anyone use accelerator with this to get the same day finish, normally use Weber which is fine but not sure about this prb,
Thanks

With the correct dosage of accelerator. You’ll get same day in these conditions

 

[Plasterers1StopShop]

Personally, I’m not a fan of accelerating the drying process, therefore would advise an overnight.

 

[owls]

Personally, I’m not a fan of accelerating the drying process, therefore would advise an overnight.

I’ve always said that, Anything that messes with the composition and with the drying process can’t be good.

 

[owls]

saying that, it was a high of 7c today. March is a tricky month for rendering as temps can be all over.

 

[Vincey]

Thanks lads no worries I’ll tell him an overnight I just didn’t want to go back for another day but sounds like it’s best Tbf nice one

 

[Plasterers1StopShop]

I’ve always said that, Anything that messes with the composition and with the drying process can’t be good.

Got to be honest, the idea of flakes, accelerators etc haunts me.

I have seen colour variation and failures where it’s been used wrong. Can cost people a lot of time and money.

Let it dry naturally is always my advice

 

[McPlaster]

I use it, deffo overnight. Nice gear.

 

[Vincey]

I use it, deffo overnight. Nice gear.

Thanks I used it in December too with the guy it was nice gear Tbf ,forgot what colour it was but had a few sparkly bits in it I noticed , very posh

 

[MakeItSmooth]

@PRB_Ryan
@PRB_Luke
@PRB_Iain

 

[PRB_Ryan]

I got a job with another lad I know he’s got a pallet of prb , does anyone use accelerator with this to get the same day finish, normally use Weber which is fine but not sure about this prb,
Thanks

We would advise going next day currently - let us know how you get on.

 

[Vincey]

We would advise going next day currently - let us know how you get on.

Got smashed in the rains today but turned out ok overnight

 

[brimplas1]

Got smashed in the rains today but turned out ok overnight
View attachment 59720

Nice job buddy...

 

[Complete]

Got smashed in the rains today but turned out ok overnight
View attachment 59720

Perfect tbh mate

 

[Vincey]

Thanks It’s nice gear I like to use the Weber and get done the same day but I’d use the prb again if I did an overnight