Thin coat to 1.5

[cjs]

hey guys going to be spraying this over the weekend first time Iv used it,any hints and tips or does and donts with this gear.

Using the eze 24 to spray it,and before I get murdered I am a ritmo user too

Base coat has all been done (hp12) and been left for about 2 n half weeks so nice and dry,going to be priming it tomorrow ready for the weekend.
Any advice greatly appreciated

 

[Arti]

@Rigsby

 

[Plasterers1StopShop]

hey guys going to be spraying this over the weekend first time Iv used it,any hints and tips or does and donts with this gear.

Using the eze 24 to spray it,and before I get murdered I am a ritmo user too

Base coat has all been done (hp12) and been left for about 2 n half weeks so nice and dry,going to be priming it tomorrow ready for the weekend.
Any advice greatly appreciated

When starting the machine, remember to open the gun fully, aiming into a bucket - then go to the wall.

Circular motions of spray, if you need to go over again that isn't a problem it will blend in

 

[Orangemachineman]

I have a decent size job coming up and I'm thinking of spraying this also

 

[cjs]

When starting the machine, remember to open the gun fully, aiming into a bucket - then go to the wall.

Circular motions of spray, if you need to go over again that isn't a problem it will blend in

I remember not to shut off or open up onto the wall lol

 

[Rigsby]

Start on speed 0 and you might go as far as 1 depending if it is a sprayed on only or rubbed up finish.

You will do ok with the eze. Size 6mm nozzle I think?

 

[22jasper]

Fart around with the speed output and air for best results. ...you'll know when you have hit the sweet spot !!