def take plasterboard off and EML over stud covering the joint between brickwork and stud then sand and cement it all. You have done everything you can to stop any cracking :hueco:
It's on small timber pediments we've bn screwing aqua panel on applying hpx and mesh the k rend ft
That's the spec we have never had and problems with it but I'm looking for an alternative to aqua panel
Any plaster worth there salt should be able to do the whole package people who just board in my eyes Arnt proper tradesmen 95% of plastered I know can board 0% of boarders I know can skim
Areas under and above windows have hairline cracks in k rend we based and meshed all the stress points and applied it to 15mm beads
personally think if render has cracked the clockwork behind it must of gone as well what does anyone else think ??????
We did same and were demoing the new mp finish the first lot we had set within 1 1/2 hours and tore wen troweling up and you couldn't fill anything out with it the rep was with us and said they were going to alter the setting times and add a bulking agent
not sure what's going on but this is...
If he had used bonding on the plasterboard u more than likely wouldn't be having any problems if what Hess put on has started coming off it more than likely all will
if it's coming off take it off hen best option is Pva then patch with bonding and skim but a patch is always a patch if once uve...
No trowel it on always mix it slow with a drill don't over mix or mix on fast or it goes to piss usually put it on then lay it down while 1st coat is still wet this usually stops it from tearing when you trowel it up
Baking powder re***ds plaster it contain allum which is used in gypsum products to help setting times when I was younger when using carlite browning we'd have batches that would set rapid so we'd chuck baking powder in to slow it down.
And man up I'm nearly 50 and still do 3 30m2 gauges a day...
The house builder we work for pay extra money if they want lads to work weekend when they are trying to get houses finished for year end usually £40 a day but in the past we have had £100 a day
Use a lot of mp finish get it from Ccf and sig stock it too it doesn't cover as well as bg and best some times to fill tapered board edges ad you go but in my opinion is far easier to work with than bg
its only drawback is its soft and is easily damaged
Try to make sure when u lay it down you get it as flat as possible and first trowel it with out any water then 2nd trowel with very little water don't mess with it or it will blister
Done some k rend recently rubbed up following day and was rock hard some bad marks in it any suggestions
could area be cut out repaired and maybe painted out ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.