Large Bellcast

[jgood]

Have a company doing EWI job at the moment. Generally very happy with them.

At the front of the house I am looking to have brick slips fitted to about hip height and these would have to be fitted later.
Whole house will have mesh & base coat applied and then finish with silicone render on the portion above where the brick slips will go.

The company want to fit a stop bead just above the line where the brick slips will finish and then finish render to that which seems fine. Trouble is that the stop bead is only a few mm deep and the brick slips are 20mm thick. I would like to have a nice transition such as a bellcast that goes out by the full 20mm or slightly more to ensure the brick slips are not sitting proud.

Is this possible with a modern silicone render and is there a suitable stop bead for this.

Any other ideas that might work such as applying a fillet mastic or sealant afterwards.

Cheers

 

[S a plastering]

Yes

 

[jgood]

Thank you for reply. Care to share any details?

 

[malc]

You can purchase stop beads at different thickness.
I have only fitted brick slips to the top gable ends with thin coat finish on the lower areas so the problem does not happen. I dont like your idea of the low area finished in brick slips.