Top coated a wall today and went too heavy on the soft! Schoolboy error.
Need to do it again. Will a slurry coat of sbr and cement hold it,without putting a key in it?
Top coated a wall today and went too heavy on the soft! Schoolboy error.
Need to do it again. Will a slurry coat of sbr and cement hold it,without putting a key in it?
Yes mate. We done a different mix this afternoon and that wall floated up well.
It will be a mornings work to re do it,so needed to know if I can just sbr slurry coat it,without a key?
it is a bit hot for rendering, but if it is just the finish that is poor, i would mix a bucket full of sand and cement about 50/50 a little sbr, very wet. with a gloved hand and a new sponge load the sponge and rub up.
Should of just scratched it and started again tomorrow unless you was working to beads. Don't put a stronger mix on top though, it will just separate over time.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.